2. Turning
1. At first, use your front arm to point to the direction you want to turn (left or right). Lean with your body to the direction your stretched arm is pointing at.
2. Lean with your body to the direction your stretched arm is pointing at. Notice that your front foot is leaning to the same direction.
3. After succeeding in steps #1 and #2, use only your feet to turn. For sharper turns, use both feet, each leaning in an opposite direction. It is recommended to perform sharp turns only in slow speed!

4. Going down hill
1. Ride the RollerSurfer in a mild, wide slope.
2. Be careful not to gain too much speed.
3. In order to slow down, you must go in a wide “zigzag” motion. Also see “Stopping with a turn”.

5. Slide
1. Ride the RollerSurfer.
2. Push both feet at the same direction carefully (toes or heels leading).
3. Balance yourself while sliding in a diagonal direction (to the riding direction).

Before mounting the board, make sure both wheels are pointing to the same direction.

Wheel alignment can be easily done by pushing the board slightly (while it is still laying on the ground) to the direction you want to go.

When placing your front leg on the front plate, make sure it is located above the wheel.

Backside switch:
1. Shift your bodyweight to your front leg.
2. Point slightly downward with your back foot’s BACK side (heel).
3. Rotate your body 180o.
4. Shift your bodyweight to your front leg again.